7
f)
Load Connection
Before load connected, turn off it. If you need control the load work ,please
connect it at controller load port. SDI-P controller defaults to directly open load.
Users can set the controller work mode as needed.
In many cases, users also can directly connect the load to the battery, but at
this time, the current between load and battery has not be detected & controlled
by the controller. We suggest user installed external fuse or breaker to avoid
excessive inrush current blown the fuse which built-in.
SDI-P series controller can be soft-start and provides a larger starting
current to the load, especially for the capacitive load equipment such as
inverters, switching power supplies, etc.
g) Running operation
After wiring, SDI-P controller will display system status and parameters and
enter the normal operating state. Once abnormal, the fault code will be
displayed.
LCD panel setup Instructions
SDI-P series comes standard with large LCD screen and 3 buttons. You can
set various functions and parameters through the panel keypad. also supports
infrared remote control(RC-3)to setup .
After battery connected, the LCD will enter normal working status in a few
seconds, the message shown in Figure 3.
