9
Figure 4 Parameter Setting Initial Screen
The user can press “up” or “down” button to select the controller parameters
which need be modified. Then
press “ok” to set it. When it flashes data can be
modified. After editing press
“ok” again. It will stop flash. Data is saved. After
setting,press“ok”in 3 seconds or no operation in 50s,it will automatic return back
to the main page.
Items
FUN
parameter
LOAD
0
Load work model
LOAD
1
1
st
period time(auto mode )
LOAD
2
Morning period time (auto mode)
PV
3
Light control voltage
PV
4
Light control delay time(minute)
BAT
5
Battery type
BAT
6
System Voltage
Note: following parameter only for battery type at DIY
BAT
7
Over voltage
BAT
8
Over discharge voltage
BAT
9
Over discharge return voltage
BAT
b
Boost charge voltage
BAT
F
Float charge voltage
Table of Parameter Selection
Controller Operate Description
1. Battery charge
after the battery type be set, SDI-P series controller
will be automatic
running, without human intervention. In special cases, the user also can
adjust parameters. The controller uses three-stage charging method provides
a fast, efficient, and safe battery charging. See the following chart Figure 5
