Ramsey Winch HD-P 4000, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 22

Installation Details
Cable Installation
An “A” or “B” decal on the clutch end bearing indicates the spooling direction of the cable. Also, a
letter “A” or “B” is stamped in the end bearing on the clutch end indicating rotation direction. If the
decal is damaged or unreadable, contact Customer Service for additional instructions to determine
proper direction. To reverse the rotation direction, exchange positions of the cartridge and plug
shown below.
1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of cable,
opposite hook, with plastic or similar tape to prevent fraying.
2. Place taped end of cable into hole in cable drum as shown below. Use the 3/8-16NC x 1/2” long
hex socket drive setscrew to secure cable to drum.
3. Carefully run winch in the "reel-in" direction. Keeping tension on end of cable, spool all the cable
onto the cable drum, taking care to form neatly wrapped layers.
After installing cable, check free-spool operation. Disengage clutch and pull on cable at a walking
speed. If cable “bird nests”, loosen jam nut and turn nylon setscrew clockwise to increase drag on
drum. If cable pull is excessive, loosen nylon setscrew by turning counterclockwise. Tighten jam
nut when proper setting is obtained.
CAUTION: OVER-TIGHTENING OF JAM NUT MAY STRIP NYLON SETSCREW.
914307 12