9a. For the air shifter, examine yoke (item
#14 for damage. Yoke should be firmly
attached to shaft. Replace if necessary.
If air cylinder (item #30) needs to be
replaced, remove it from the end of the
clutch housing by removing 4 cap-
screws (item #25) and lockwashers
(item #27). Inspect the breather vent
(item #38) and elbow connector (item
#29) to ensure they are not plugged.
10.Check cover bushing (item #15) for
signs of wear. If necessary remove old
bushing and press bushing into place.
11.Apply grease to end of shaft, oppo-
site gear. Apply grease to bushing in
gear housing (item #10). Place
greased end of shaft through thrust
washer (item #46) and bushing in
gear housing (item #10). Place gas-
ket (item #30) onto gear housing
cover (item #6). Apply grease to
gear end of shaft and cover bushing.
Place cover onto shaft and secure to
housing with ten (item #18) cap-
screws. Tighten capscrews to 8 ft.
lbs. (10.8 Nm.) each.
RE-ASSEMBLY
12
10
26
47
14
30
29
38
25
41
36
45
16
27
