Ramsey Medical petMAP graphic II 7300, Руководство оператора

Страница: 36 / 40

36
before the deflation step. Test the cuff on your finger to observe the deflation steps to
determine whether the cuff or hose is leaking. Try another cuff if in doubt to confirm proper
operation. Discard any leaking cuff, as using a leaking cuff will result in inaccurate readings.
Cuff will not inflate.
1. Check cuff connections, both at the cuff port of the device and any connections between the
cuff and the extension hose. Check cuff and extension hose for leaks or damage.
2. Verify that the pump is actuating (you will hear the noise and feel a slight vibration) when BP
Start/Stop is pressed. If not, contact Customer Service.
Screen buttons don’t respond in the expected way to touch.
It’s possible that the touchscreen needs recalibration. To do so:
1. Turn the unit OFF.
2. To enter the setup mode, press your thumb or finger gently on the screen and then turn the unit
ON while continuing said pressure on the screen. When the counter in the upper left reaches
exactly 8, release your thumb or finger from the screen and follow the screen instruction (See
Figure 1).
3. Follow the prompts on the screen by touching the arrows with a pointed object like a stylus or
pencil. Do not use a sharp pointed object in order to avoid damage to the display (See Figure 2).
4. The unit will acknowledge each successful touch by beeping and counting down before moving
to a different screen location.
5. Once all three locations have each been touched three times, touch the screen anywhere to exit
the screen calibration function.
6. When the unit exits the setup mode and returns to its normal operating mode, verify that the
touch buttons work as expected.
Figure 1
Figure 2