UT5A
25
FAULT
:
Wrong Frequency Range in Astable mode
SOLUTIONS:
Insure JMP4 is removed
Insure JMP5 is removed and no Control Voltage is applied
FAULT
:
Unit will not start when S1 is pressed in Monostable Mode
SOLUTIONS:
Verify JMP2 is installed
Verify JMP4 is installed
FAULT
:
Output signal matches the input square wave
SOLUTIONS:
Remove JMP3 to install the differentiator
If you are still unable to solve your kit problems you may send your kit in for
repair. For instructions on how to return kits for repair please see the “Factory
Repair of Assembled Kits” section of our Ramsey Kit Warranty page on the
inside back cover of this manual. You may also contact our Technical Support
Department at :
Phone:
(585) 924-4560
Email:
Address:
Ramsey Electronics, LLC
Attn. Hobby Kit Department
590
Fishers
Station
Drive
Victor,
NY
14564
