Ramsey Electronics LEDS1, Быстрая справочная страница инструкции

Страница: 9 / 24

LEDS1
•
9
LEDS1 PC BOARD ASSEMBLY STEPS
ˆ
1. Let’s begin with all the jacks at the bottom of the board. Install J2, the
power jack in the lower right hand corner.
ˆ
2. Install R6, 1K ohm resistor [brown-black-red], under R5.
ˆ
3. Install J5, another power jack next to J2. This is the jack that connects
to the LED board.
ˆ
4. Now, let’s start soldering in some real components. Start with R17,
100K ohm resistor [brown-black-yellow] in between J5 and J2. This is the
audio input jack.
ˆ
5. Install RCA jack, J1.
ˆ
6. Install J3, 3.5mm stereo jack, next to J5. This jack is for external
triggering and connecting two LEDS1’s together.
ˆ
7. Install R20, 100K ohm resistor [brown-black-yellow] next to J1.
ˆ
8. Install C14, .1 uF ceramic disk capacitor [marked 104], next to R20.
ˆ
9. Install C13, .1 uF ceramic disk capacitor [marked 104], next to C14.
ˆ
10. Install R2, 10K ohm resistor [brown-black-orange], next to C13.
ˆ
11. Install R1, 10K ohm resistor [brown-black-orange], above C13.
ˆ
12. Install U1, LM324 [marked LM324N] above R1. Make sure the notch
at one end of the IC lines up with the notch on the board drawing.
ˆ
13. Install R9, 22K ohm resistor [red-red-orange], at the right end of U1.
ˆ
14. Install C5, .001 uF capacitor [marked 102] next to R9.
ˆ
15. Install R3, 10K ohm resistor [brown-black-orange] next to C5.
ˆ
16. Install C4, .001 uF ceramic disk capacitor [marked 102], under R3.
ˆ
17. Install C3, .001 uF ceramic disk capacitor [marked 102], under C4.
ˆ
18. Install R13, 68 ohm resistor [blue-gray-black].
ˆ
19. Install R12, 68 ohm resistor [blue-gray-black].
ˆ
20. Install C6, .001 uF ceramic disk capacitor [marked 102], next to R3.
ˆ
21. Install R14, 68 ohm resistor [blue-gray-black], to the right of C6.
ˆ
22. Install VR1, 7805 5V regulator. This powers the ICs on the board. The
writing on the regulator faces D11.