FM-100 Page 43
4M. Your 110VAC line cord has three wires; black, white, and green. The
black wire does not have a factory installed Molex pin on it; this is the
HOT side of the power connection. Strip and tin the end of the black wire.
5M. Locate the female Molex connector and insert the white linecord wire,
as shown, into the jack. You will notice there is a small catch tab on one
side of the pin. Insert the pin into the Molex jack so the tab faces the side
with the slotted holes. You should hear a small “click” when installed
properly.
6M. Install the center green wire and pin into either of the center holes of
the Molex jack. Make sure it clicks into place. Both the center holes are
connected together on the PC board.
7M. Install the 3” piece of line cord wire with Molex pin attached into the
other side of the Molex jack.
8M. Install the fuse holder in the back of the case so that the cap is on the
Содержание FM-100
Страница 17: ...FM 100 Page 17 SECTION LAYOUT ON MAIN BOARD...
Страница 21: ...FM 100 Page 21 MAIN BOARD PART VALUES...
Страница 22: ...FM 100 Page 22 MAIN BOARD PART LAYOUT...