![background image](http://html2.mh-extra.com/html/ramsey-electronics/fm-100/fm-100_assembly-and-instruction-manual_3615198042.webp)
FM-100 Page 42
M. REAR PANEL WIRING
L. 1 WATT MODULE
1L. Note the position of C92 on the PC
board. Do not install any part in this
position.
2L. Install R33, a 1K ohm stand up
resistor (brown-black-red).
3L. install D5, a 1N4148 type diode (small
glass orange body with black stripe on
one end). Make sure and mount the stripe
in the same direction as shown in the
parts layout.
4L. Install R39, a 1K ohm resistor (brown-
black-red).
5L. Install C91, a 100pF ceramic
capacitor (marked 100 or 101).
6L. Install C79, a .01uF ceramic capacitor (marked 103, .01 or 10n).
7L. Install C83, a .01uF ceramic capacitor (marked 103, .01 or 10n).
8L. Using a scrap piece of component wire, install a wire in the hole
marked TP2. Make sure this wire is long enough to connect a DMM meter
probe to.
This section of parts will not be needed until you install the 1 watt module.
Check all of your parts for correct installation and clean solder connections.
1M. Find the parts indicated in the diagram.
2M. Insert rubber grommet into the line cord hole, this will be used as a
strain relief.
3M. Thread the line cord through the grommet in the back panel. Make
sure the plug end is on the silk screen side of the panel, and the Molex
end of the line cord is on the non-silk screen side (inside the case).
Содержание FM-100
Страница 17: ...FM 100 Page 17 SECTION LAYOUT ON MAIN BOARD...
Страница 21: ...FM 100 Page 21 MAIN BOARD PART VALUES...
Страница 22: ...FM 100 Page 22 MAIN BOARD PART LAYOUT...