Ramsey Electronics CUBE 2000, Инструкция по эксплуатации

Страница: 8 / 12

C2000
•
8
TROUBLESHOOTING:
If you're having trouble getting your C2000 to work properly,
check to be sure that:
•
your battery is connected correctly; red wire soldered to the
pad marked "RED" and black wire soldered to the pad
marked "BLK". Also be sure your solder connection is solid.
•
you have a good 9 volt battery pack.
•
your video source is operating properly. Try connecting your
camera directly to a TV or VCR and make sure you have a
good, clean picture. Once you've checked your camera,
solder its video output to the pad marked "YEL" NOTE: If
you are using a video source or camera other than a Ramsey
CCD camera, make sure your source has a 1 volt peak to
peak video signal.
•
you have the ground or negative power connections on both
the camera power source and the Cube power source
connected to the Cube.
Both grounds need to be connected
to the Cube for proper operation.
•
you have the antenna properly connected to the CABLE IN
jack on your receiver.
•
you have the TV set for CABLE channel 59. Your TV or VCR
should be set to CATV not AIR. If you're having trouble
setting up your TV or VCR, refer to your owners manual. The
C2000
will not work if your TV or VCR is not set to CABLE.
If none of the preceding has helped, refer to the Ramsey
Warranty section of this manual.