FASTENERS
The TrakFast tool can drive only Ramset
fasteners which have been collated into
strips . Any other fastener will cause tool
damage and void your warranty .
LOADING FASTENERS
The illustration below shows how to properly
load fasteners into the TrakFast tool .
1 . Pull the carrier assembly back until it locks .
2 . Load four fastener strips into the rear slot
of the magazine .
3 . Pull the carrier assembly slightly back,
push the follower button in, and gently
release the assembly to engage the
fasteners .
The Trigger on the TrakFast tool is automatically
locked and will not operate when there is
less than 2 fasteners in the feed magazine
and unless the work contact element is fully
depressed . The purpose of this feature is to
prevent needless blank cycling, which could
damage tool components .
DANGER
Two (2) fasteners will be left in the Magazine
after strips have been used . At this point
you can reload . It does not indicate that the
tool is empty . Because of a lockout feature
in the TrakFast tool, it will not operate when
the fastener supply in the tool is less than
two (2) fasteners .
TRAKFAST TOOL OPERATION
Press Work Contacting Element Against
Work Surface
Fan Motor will
turn on .
LED will be
steady green .
Fuel is injected
into Combustion
Chamber and
mixed with air by
the Fan .
Squeeze
the Trigger
The Spark Plug
sparks and fuel/
air mixture ignites .
Combustion
powers the Piston
Assembly driving
fastener .
Release Trigger—Lift the Tool
The Combustion Chamber opens .
Fan exhausts hot gases and cools internal
components .
NOTE:
if no additional cycles are made, fan
will run for 7 seconds and then shut off .
WARNING
The Work Contacting Element and nose
may become hot after prolonged or rapid
use .
PREPARING AND USE OF TRAKFAST TOOL
PREPARING AND USE OF TRAKFAST TOOL
11