RAMSET 721, Руководство оператора и инструкция по установке

Страница: 10 / 16

4. Slide the barrel back to the semi-closed
position. Never attempt to close the
tool by exerting force on the front end
of the barrel.
Never place your hand,
fingers or any other body part over the
fastener loading end of the tool.
5. Hold the tool perpendicular (90°) to
the work surface with both hands and
press firmly to fully depress the tool.
Maintain firm downward pressure
on the tool with both hands and pull
the trigger to drive the fastener.
DO
NOT DEPRESS THE TOOL AGAINST
ANYTHING OTHER THAN THE
INTENDED WORK SURFACE.
Holding
the tool firmly in place will produce more
consistent fastening quality and
minimize tool wear or damage
6. After making the fastening, point the
tool in a safe direction, and snap the
tool downward to cause the barrel to
move to the open position. This action
ejects the fired load case and properly
resets the piston for the next fastening.
Should a fired load fail to eject, open
and close the tool several times to
loosen the load in the chamber, then
remove the load with your fingers.
Never attempt to pry an unfired load
out of the tool chamber.
The load
could be caused to discharge resulting
in a serious injury or death to the tool
operator or to a bystander.
7. Insert another fastener in the muzzle
end of the tool before inserting a new
powder load into the chamber.
Always
insert the fastener into the tool before
inserting the powder load.
Keep your
finger off of the trigger until the tool is
in position to drive the fastener.
Never
carelessly discard or throw unfired
powder loads into a trash container.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
SLIDE THE BARREL BACKWARD TO THE
SEMI-CLOSED POSITION
HOLD TOOL FIRMLY AND
PERPENDICULAR TO THE WORK SURFACE
EJECT THE LOAD
INSERT THE NEXT FASTENER