10
III OPERATION
MOUNTING ATTACHMENTS
INSTALLATION OF ATTACHMENT
1.
Rotate Lock Pins to the unlock
position (handle pointing outwards).
2.
Tilt the attachment frame forward as
show in Figure 7, so that the top
round edge of the attachment frame
will fit under the lip of the
attachment.
3.
Drive into the attachment, raising the
arms so that the top of the
attachment frame slips under the lip
on the attachment, and attachment
lifts slightly.
4.
Using the tilt cylinder, roll back the
attachment so it drops into place, as
shown in Figure 8
5.
Rotate the lock pins to the locked
position (handles facing inwards),
and check that the lock pins are fully
inserted through the lock holes in the
attachment.
6.
Connect attachment hydraulic hoses
(if required) to the quick couplers as
shown in Figure 9.
WARNING
After Hook-Up To Attachment, Check To
be Sure Lock Pins Are Fully Engaged
and Locked Into Position
REMOVAL OF ATTACHMENT
1.
Lower lift arms and tilt forward on
the attachment so that the attachment
is resting on the ground.
2.
If
attachment
is
hydraulically
equipped, stop the engine, relieve
hydraulic pressure in the attachment
lines by shifting the auxiliary lever
back and forth, and disconnect the
attachment.
Figure 7
Figure 8
Figure 9
3.
Rotate the lock pins to the unlocked
(handles pointing outwards) position.
4.
Start engine, tilt the attachment
mount frame clears that lip on the
attachment, and back the Mini-Skid
away from the attachment.
