5
PREPARE TO ASSEMBLE THE APPLIANCE
Check for damage on the appliance. If damage occurs, please contact Austcrown or your
dealer. Do not use a damaged appliance.
WARNING! It is hazardous to use a damaged appliance.
Positioning the Appliance
Only use the appliance in well ventilated areas. The appliance must be sited with at least a
1000mm gap between both sides and the rear of the appliance and at least 2700m from the
trivet of the appliance and any combustible or non-combustible materials above the appliance.
When the burner is assembled abutting a side or rear wall, the wall must be of non-combustible
material, e.g. ceramic tiles. If surrounding walls are constructed with a combustible material,
contact your local Gas Authority for information on clearances required.
The appliance must be used on a level, stable, non-flammable surface when in use. If used on
the ground in an area with long grass ensure that the grass is not long enough to enter under
the appliance or at the sides as this could result in the grass catching fire.
This appliance shall only be used in an above ground open air situation with natural ventilation,
without stagnant area’s, where gas leakage and products of combustion are rapidly dispersed
by wind and natural convection.
It is important that the ventilation openings of the appliance are not obstructed.
The appliance should be protected from direct draughts and be positioned or protected against
direct penetration by any trickling water (e.g. rain).
If the appliance is install at outdoor, a proper shelter with well ventilation should be use to
protect the appliance from draughts and rain. Some examples of shelter are shown below,
IMPORTANT:
The dimension and building materials of the shelter must be meet the
requirements mentioned below, or contact your gas filter / local Gas Authority for information on
clearances and material required
DIAGRAMMATICAL REPRESENTATION OF OUTDOOR AREAS
note this page and the next page
This appliance shall only be used in an above ground open-air situation with natural ventilation, without
stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural
convection. Any enclosure in which the appliance is used shall comply with one of the following:
An enclosure with walls on all sides, but with no overhead cover (see figure 1).
Fig. 1
Содержание HPA100LPB
Страница 13: ...13 ...