GB010203
5
Do not spray aerosols in the vicinity of this country cooker while it is in operation
Do not use this appliance where petroleum products or other liquids having flammable vapours are stored or
used.
Do not hang clothing or other flammable material on or near this appliance.
Children and adults should be alerted to the high temperatures of the country cooker and its effect on
surrounding surfaces, clothing and skin.
Children or the elderly should be supervised when near this appliance
If the country cooker fails to operate correctly, contact place of purchase or their authorised agent for advice
and service. DO NOT CONTINUE TO USE THE APPLIANCE and DO NOT ATTEMPT REPAIRS YOURSELF.
OPERATING INSTRUCTIONS
LIGHTING THE BURNER:
1. Before lighting, ensure the country cooker is on a level non-combustible surface outdoors and required
minimum Clearances from combustible surfaces are maintained as follows: at least 250mm from REAR OR
SIDES and at least 1200mm OVERHEAD.
2. Check the gas hose and rubber seal o
r ‘O’ ring of regulator inlet fitting for signs of damage, abrasion or
cracking
– PVC hoses may harden with age - replace the hose and regulator assembly if any damage is
evident.
3. Ensure the gas supply hose is connected to the gas inlet of the country cooker and the regulator is
connected to the LP cylinder and check that both connections are tight
– refer sections 5 & 6 of assembly
instructions.
4. Turn on the LP cylinder valve in a counter clockwise direction and check for gas leaks as previously
described in section 7 of the assembly instructions.
5. Turn the appliance control valve counter-clockwise until the lever is in line with the burner and light the
burner with a long taper or long match.
6. Turn the bolt at the left hand side of the venturi back and forth until you get nice blue flame. This step is
important, as it ensures there is a right mix of air and gas to achieve a blue flame.
7. The burner may now be adjusted to the desired flame setting.
Turn control valve clockwise for low flame or counter-clockwise for high flame.
SHUTTING DOWN THE BURNER:
1. Turn LP cylinder gas
valve fully clockwise to “OFF” position. The gas must always be turned off at the
cylinder to ensure there is no gas flow and that no gas remains in the regulator, hose and appliance during
non-use/storage.
2. Once the flame has gone out, Turn appliance control valve
(s) to “OFF” position, which is at 90
to the line
of the burner.
DO NOT TOUCH HOT SURFACES, ALLOW THE COUNTRY COOKER TO COOL BEFORE CLEANING IF
NECESSARY.
ANCILLARY SERVICE INFORMATION
MAINTENANCE
SERVICE INSTRUCTIONS FOR LISCENSED GAS FITTER OR PLUMBER.
(a) Remove all covers and other parts for access to all components.
(b) Remove all components for services.
Do not attempt any maintenance within 30 minutes of country cooker being used.
Burner ports may be cleaned with either compressed air or pipe cleaner or similar device.
Any spiders’ webs formed in the burner inlet must be cleared with a pipe cleaner or similar length device.
Caution: Operation of the burner with a web in the inlet may result in leakage and/or ignition of gas at the burner
inlet.
It is also recommended that the hose assembly and regulator inlet fitting seals be checked for damage, abrasion,
cracking or displacement before each use. PVC hose assemblies may harden with age and should be replaced if
this occurs. If a replacement part or assembly is required please contact place of purchase or an authorised agent
for advice.
Содержание GB01LP
Страница 7: ......
