1 -
Switch for microphone input selection. It takes over switch
3
.
2 -
Microphone input selection indicator.
3 -
Line 1 / Line 2 selector, enable only when switch 1 is released
4 -
Line 1 indicator
5 -
Line 2 indicator
6 -
Input sensibility pot control (range 28dB)
To set, input signal , and adjust to get 0dB on the display
15
.
7 -
High control pot. Range -12/+12dB, middle is neutral.
8 -
Mid control pot. Range -12/+12dB, middle is neutral.
9 -
Low control pot. Range -12/+12dB, middle is neutral.
10 -
Send to hybrid control.
11 -
Key to send stereo to ANTENNA, with associated indicator
12 -
Key to send stereo to PGM2/REC, with associated indicator
13 -
Cue key, and associated indicator. Sens audio to the display, and headphones even is fader
16
is closed.
14 -
Start and associated indicator. It requires two actions:
On one hand: First key
14
must be on and fader
16
, slightly open. This allows START action
Either fader closed: press switch
14
, and equipment starts on fader opening
Other fader
16
open around 0dB, pressing key 14 starts the equipment.
On the other hand:
Starting the equipment using H connector on the rear panel works only with Line 1 or Line 2 (switch
1
released)
If switch
1
is on, using microphone the start signal is sent to an internal bus, to the Y connector on the
output channel (see page 18) allowing to switch on the On Air signal
15 -
Led peakmeter display.
16 -
Long track fader driving a VCA (Voltage Control Amplifier).
INPUT CHANNEL 1: MIC1 / LINES 1 & 2 - FRONT PANEL
RAmi
RP500
9
