RAM 2014 TRUCK 1500, Руководство пользователя

Страница: 21 / 196

Installing Three Child Restraints:
1. Place a child restraint on each out-
board rear seat. Route the tether
straps following the directions for
right and left seating positions, above.
2. Attach both hooks to the center tether
strap loop, but do not tighten the
straps yet.
3. Place a child restraint on the center
rear seat. Route the tether strap fol-
lowing the directions for the center
seating position, above.
4. Attach the hook to the outboard tether
strap loop.
5. Tighten the tether straps according to the child seat manufacturer’s instructions,
tightening the right and left tether straps before the center tether strap.
Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first, pull enough of the seat belt webbing from the
retractor to route it through the belt path of the child restraint and slide the latch
plate into the buckle.
• Next, extract all the seat belt webbing out of the retractor and then allow the belt
to retract into the retractor. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt system will loosen with time, so
check the belt occasionally, and pull it tight if necessary.
• Route the tether strap to provide the most direct path for the strap between the
anchor and the child seat, preferably between the head restraint posts underneath
the head restraint.
• Attach the tether strap hook of the child restraint to the tether anchor and remove
slack in the tether strap according to the child restraint manufacturer’s instructions.
NOTE:
Ensure that the tether strap does not slip into the opening between the seatbacks as
you remove slack in the strap.
Left Outboard And Center Seating
Position Shown
GETTING STARTED
19