RAM 1500 CLASSIC 2022, Руководство пользователя, Страница: 44 / 364

42 GETTING TO KNOW YOUR VEHICLE
P
ROGRAMMING
H
OME
L
INK
® T
O
A
G
ARAGE
D
OOR
O
PENER
To program any of the HomeLink® buttons to
activate your garage door opener motor, follow the
steps below:
NOTE:
All HomeLink® buttons are programmed using this
procedure. You do not need to erase all channels
when programming additional buttons.
1. Place the ignition switch into the ON/RUN
position.
2. Place the garage door opener transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink® button you wish to program.
3. Push and hold the HomeLink® button you
want to program while you push and hold the
garage door opener transmitter button you are
trying to replicate.
4. Continue to hold both buttons until the
instrument cluster display changes from
“CHANNEL # TRAINING” to “CHANNEL #
TRAINED,” then release both buttons.
NOTE:

It may take up to 30 seconds or longer in some
cases for the channel to train.

If “DID NOT TRAIN” appears in the instrument
cluster display, repeat from Step 2.

Make sure the garage door opener motor is
plugged in before moving on to the rolling code/
non-rolling code final steps.
Rolling Code Garage Door Opener Final Steps
NOTE:
You have 30 seconds in which to initiate rolling
code final step 2, after completing rolling code
final step 1.
1. At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAIN”
button. This can usually be found where the
hanging antenna wire is attached to the
garage door opener motor. Firmly push and
release the “LEARN” or “TRAIN” button.
2. Return to the vehicle and push the
programmed HomeLink® button three times
(holding the button for two seconds each
time). The instrument cluster display will show
“CHANNEL # TRANSMIT.” If the garage door
opener motor operates, programming is
complete.
NOTE:
If the garage door opener/device does not
activate, push the button a third time (for two
seconds) to complete the training.
To program the remaining two HomeLink®
buttons, repeat each step for each remain -
ing button. DO NOT erase the channels.
Non-Rolling Code Garage Door Opener Final Steps
1. Place the ignition switch in the ON/RUN
position.
2. Place the hand-held transmitter 1 to 3 inches
(3 to 8 cm) away from the HomeLink® button
you wish to program.
3. Push and hold the HomeLink® button you
want to program while you push and hold the
hand-held transmitter button.
4. Continue to hold both buttons until the
instrument cluster display changes from
“CHANNEL # TRAINING” to “CHANNEL #
TRAINED,” then release both buttons.
NOTE:

It may take up to 30 seconds or longer in
some cases for the channel to train.

If the instrument cluster display shows “DID
NOT TRAIN”, repeat from Step 2.
22_DS_OM_EN_USC_t.book Page 42