Documentation Center
5. Install BSP support for Arduino as described on section BSP Installation
https://github.com/RAKWireless/RAK4600_Arduino#bsp-installation
📝
NOTE:
Before upload any Arduino example make sure that the RAK4600 is on DFU mode.
1. Connect the RX pin of RAK4600 to GND.
2. Press the reset button and then disconnect RX pin from GND. Now the RAK4600 is on DFU mode.
Connecting to The Things Network (TTN)
Please refer to
Connecting to The Things Network (TTN)
Connecting with Chirpstack
Please refer to
Miscellaneous
RAK5005 Core Module Slot Connection to RAK4601
The RAK5005 is the base board that connects the RAK4600 Core Module. It creates the power supply for the
attached module, and provides additional IO and Sensor support for your project needs.
📝
NOTE
RAK4601 is a circuit board module for RAK5005 with pre-soldered RAK4600 LPWAN Module.
Listed below are the accessible pins and data bus of attached RAK5005 base board on the RAK4600 EVB:
cd
RAK4600_Arduino
pyocd flash -t nrf52 feather_nrf52832_bootloader.hex
sh
