background image

Installation of the WCM with screwed finish plates (WVF): 

Step 1  

 

Prepare cable(s) in backbox ready for connection. 
 
Seperate the two halves of the WCM ready for 
installation. The “back” section (with the 
punchdown connections) will be installed first.  
 

TIP

Leave plenty of slack if possible to allow for 
re-punching down at a later date if required.  

Step 2  

 

Punch down cable(s) matching cable colours to 
colours written on the circuit board. There may be 
either one or two sets of cables to punch down.  
 
Terminate the WCM as required. See 
“Terminating the WCM” on page 4 of this manual.  
 
 
 

Step 3  

 

The back section of the WCM is now installed and 
is ready for the front section and cover plate.  
 

 
 
TIP: 

Take care when preparing and installing not to disturb 
the punch down connections. Loops are provided on 
the back section to cable tie the cable(s) if desired. 

Step 4  

 

Clip the transparent surrounding mounting plate 
and the WCM front board together. 
 
Fit the WCM front board and attached surround to 
the WCM back board.  
 

TIP: 

If the wired network is powered then the backlit LEDs 
on the keypad should illuminate once the two halves 
are connected together. 

 

Step 5  

 

Finally screw the cover plate into the back box 
through the screw holes in the transparent 
surround.  
 
Installation of the WCM is now complete.  

WCM-070

Manual Version 2.0.2 

Содержание WCM-070

Страница 1: ... can be wired in two ways Daisy Chain configuration A single run of keypads runs from the RAK LINK and to an end point It is still usually advisable to run a return leg back to the RAK LINK as a spare STAR configuration Cables are all run back to a central point a RAK STAR usually located with the RAK LINK Each cable can be from a single keypad or a leg of keypads Installation Note The WCM comes i...

Страница 2: ...inate the WCM as required See Terminating the WCM on page 4 of this manual The back section of the WCM is now installed and is ready for the front section and cover plate TIP Take care when preparing and installing not to disturb the punchdown connections Loops are provided on the back section to cable tie the cable s if desired Step 4 Clip the front section of the WCM into the grid and connect th...

Страница 3: ...e 4 of this manual Step 3 The back section of the WCM is now installed and is ready for the front section and cover plate TIP Take care when preparing and installing not to disturb the punch down connections Loops are provided on the back section to cable tie the cable s if desired Step 4 Clip the transparent surrounding mounting plate and the WCM front board together Fit the WCM front board and a...

Страница 4: ...re configuration For the example the WCMs marked STAR TERM on page one Programming the WCM The WCM is programmed using the Rasoft Pro programming software A WA WTC Bridge is required for any programming of a wired system Wired system Programming Guide For information on how to programme the wired system using Rasoft Pro Troubleshooting the Wired Network Sometimes cabling problems or incorrectly pu...

Отзывы: