Installation of the WCM with screwless finish plates (WLF/WLM):
Step 1
Prepare cable(s) in backbox ready for connection.
Separate the two halves of the WCM ready for
installation. The “back” section (with the
punchdown connections) will be installed first.
TIP
:
Leave plenty of slack if possible to allow for
re-punching down at a later date if required.
Step 2
Punch down cable(s) matching cable colours to
colours written on the circuit board. There may be
either one or two sets of cables to punch down.
Step 3
Terminate the WCM as required. See
“Terminating the WCM” on page 4 of this manual.
The back section of the WCM is now installed and
is ready for the front section and cover plate.
TIP:
Take care when preparing and installing not to disturb
the punchdown connections. Loops are provided on
the back section to cable tie the cable(s) if desired.
Step 4
Clip the front section of the WCM into the grid and
connect the front section of the WCM to the back
section of the WCM.
Screw the grid for the screwless cover plate into
the backbox.
TIP:
If the wired network is powered then the backlit LEDs
on the keypad will illuminate.
Step 5
Clip the cover plate into the grid to complete
installation.
WCM-070
Manual Version 2.0.2
