WWW.RAISE3D.COM
AMERICA · ASIA · EUROPE
Filament Run-out Sensor Installation Guide
STEP 6: Assemble the Filament Run-Out Sensor
STEP 7: Check the Filament Run-Out Sensor function
Power on the printer. Check whether the red lights on sensor are on or not with no filament passing
through the sensor. If the lights are on, please power off the printer and move onto the next steps.
If the lights are not on, please contact support at help.raise3d.com.
STEP 8: Replace the Bowden Tube
1) If the original Bowden Tubes on your printer are with
4mm-OD
:
Remove the original Bowden tubes completely and replace them with the included Bowden tubes
from the Run-Out Kit (D). To release the tubes, press and hold the blue ring on the coupling.
Connect the white Filament Run-Out Sensor cable (B) to the
Filament Run-Out Sensor (A). Remove the tape covering.
