11
Salt Setting (lbs/cu ft)*
Model
2.0
2.5
3.0
4.5
6.0
8.0
10.0
12.0
15.0
30C
0.9
1.0
1.3
1.9
2.5
3.4
4.2
5.0
6.3
40C
1.0
1.3
1.5
2.3
3.0
4.0
5.0
6.0
7.5
Table 1 : Refill time (in minutes) for various salt settings using Sodium Chloride
*
Salt settings not validated by IAPMO
Disinfecting the Softener
It is possible that during shipping, storage & installing, bacteria can go into the unit.
Therefore, as a good installation practice, it is recommended that the softener be disinfected
prior to use. To disinfect, open the lid of the brine well in the salt tank and add approx. 3
tablespoons of fresh common household bleach. Replace lid & proceed to next step.
Manual Regeneration
If screen is locked, press
MENU
key for 3 seconds to unlock. To initiate an immediate regeneration, press the
SET/REGEN
button for 3 seconds, an option for “
Delayed
” or “
Immediate
” regeneration will appear. Press the
SET/REGEN
button again and “
Delayed
” will begin flashing. Now press the down arrow button and “
Immediate
” will
flash. Press the
SET/REGEN
button once and then press the menu button once. Valve will immediately start manual
regeneration.
YOUR UNIT IS NOW READY FOR SERVICE
F.
OTHER FEATURES
Control Operation During a Power Failure
In the event of a power failure, the valve will keep track of the time and day for 48 hours. The programmed settings
are stored in a non-volatile memory and will not be lost during a power failure. If power fails while the unit is in
regeneration, the valve will finish regeneration after power is restored. If the valve misses a scheduled regeneration
due to a power failure, it will queue regeneration at the next regeneration time once power is restored.
Safety Float
The brine tank is equipped with a safety float which prevents your brine tank from overfilling as a result of a
malfunction such as a power failure.
New Sounds
You may notice new sounds as your water softener operates. The regeneration cycle lasts approximately 2 hours.
During this time, you may hear water running intermittently to the drain.
8
Refill Flow Rate
0.7 GPM
Leave at default setting
9
Unit Capacity
For 30C unit, set at 33,000 grains if you chose 15 lbs salt/ft³ otherwise leave at default
For 40C unit, set at 40,000 grains if you chose 15 lbs salt/ft³ otherwise leave at default
10
Reserve Capacity
75
gal/person
Increase or decrease value as desired
11
Capacity
This will be the calculated unit capacity in US Gal. The unit will regenerate only when this much
water has been used.
12
Backwash
05
Increase to 10 if water has lot of dirt or rust
13
Brine / Rinse
50
Increase to 60 if water is more than 15
grains hard
14
Rapid Rinse
5
Increase to 10 if you want a longer rinse
time after regeneration
15
Refill
For REFILL settings based on your chosen salt settings, please refer to
Table 1
below
16
Restore Default
NO
Leave at default. Change only if you would like
to re-start programming from the beginning
Open this lid &
pour bleach inside
