Wiring the PT5002
WIRING THE PT5002
At installation, be sure to comply with the following requirements:
•
Disconnect power to the unit before attempting any connection or service to
the unit�
•
Avoid using machine power service for AC power� When possible, use a
dedicated circuit or a lighting circuit�
•
Observe all local electrical codes�
•
The unit must be wired with wires and/or cables with a minimum temperature
rating of 167° F (75° C)�
TO PREVENT ACCIDENTS, DO NOT APPLY POWER UNTIL ALL OTHER
CONNECTIONS HAVE BEEN COMPLETED.
Figure 4: One sensor input, analog output
THE PT5002 IS MICROPROCESSOR CONTROLLED. IT IS VERY IMPORTANT THAT THE
POWER SUPPLY BE FREE OF ELECTRICAL NOISE. AVOID USING POWER LINES THAT
FEED HEAVY LOAD ELECTRICAL DEVICES SUCH AS PUMPS AND MOTORS.
Page 11
June 2020
