Rain Bird Gold LINK 900, Руководство пользователя, Страница: 18 / 35

17
September 2015
Set the baud rate for the LINK900 radio in the Command Line Mode under the Utilities menu.
Type “BAUD 600 8N1” and Enter. Confirm the baud rate is set to 600 8N1 by typing “BAUD” and
hitting Enter.
Confirm the Port is set to TTL by typing PORT and hitting Enter. PORT TTL should be displayed.
If RS232 or RS485 is displayed, the radio is not a LINK900 radio.
Note that the “Network Address” shown in the Configuration Settings/Network section needs to
be the same as the address used on the Master radio. The Extension Address (in light green) for
each Extension radio must be programmed with a unique (XADDR) value between 1 and 31.
The Primary Extension Address (XPRI) setting (in yellow) is shown here with an XPRI value of
“0” to receive its commands from the Master. If this Extension radio is to receive its signal from
another Extension radio, the XPRI value should match the XADDR value of the Extension radio
relaying the signal. Refer to Figure A for a visual representation.
If the signal needs to be repeated but there are no field controllers available to do so, a
Standalone Repeater radio is available.
The Standalone Repeater radio kit (p/n IQ4630) is programmed as an Extension radio, with the
same settings as mentioned above. Please note that the Standalone Repeater radio cannot be
used to replace the LINK900 radio/modem/antenna kit needed for field controllers.