Rain Bird Gold LINK 900, Руководство пользователя, Страница: 16 / 35

15
September 2015
Set the baud rate for the LINK900 radio in the Command Line Mode under the Utilities menu.
Type “BAUD 600 8N1” and Enter. Confirm the baud rate is set to 600 8N1 by typing “BAUD” and
hitting Enter.
Confirm the Port is set to TTL by typing PORT and hitting Enter. PORT TTL should be displayed.
If RS232 or RS485 is displayed, the radio is not a LINK900 radio.
Note that the “Network Address” shown in the Configuration Settings/Network section needs to
be the same as the address used on the Master radio. The Primary Extension Address setting is
shown here with an XPRI value of “0” to receive its commands from the Master. If this Remote
radio needs to be configured to receive its signal from an Extension radio, the Primary Extension
Address (XPRI) value should match the Extension Address (XADDR) value of the Extension radio
relaying the signal. Please refer to Figure A.
Figure A
Figure A above depicts the different configurations that can be seen when using the LINK900
radios to transmit the signal from the Master to Remote and Extension radios. Extension radios
repeat the signal on a unique extension address defined by the Extension Address XADDR value.
The signal from the Master may be repeated by a maximum of 4 Extension radios before
terminating at a Remote Radio.