Rain Bird ESP-6LX+, Инструкция по установке, программированию и эксплуатации, Страница: 29 / 73

26 ESP-LX+ & LXi+ Installation, Programming, & Operation Guide
The MV / Pump start setting affects the station in all programs
to which it is assigned.
CAUTION : If an unused station is turned on and
activates a pump start relay, the pump may overheat
or cause a pipe to burst. To prevent operating a pump
with no flow ( deadheading ), make sure all unused
stations have a zero run time.
Set MV / Pump Starts
You can assign a master valve relay or a pump start relay to
each station. This means that any time the station operates, the
relay assigned to it will also turn on. For example, if a specific
station needs additional water pressure, you may want to
activate a booster pump whenever that station turns on.
NOTE : Stations that have a master valve / pump
relay assigned to them must be wired properly to
activate the relay. See pages 53-55 for instructions.
➊
Turn the dial to “MV or PUMP SELECT.”
➋
The display shows the station number and “MV ON” or
“MV OFF.” The station number flashes.
➌
Press ñ or ò to select the station number you want to
set.
➍
Press “MAN. START/ADV.”