2. We do not recommend users to disassemble the device without proper instructions and
authorization. The manufacture warranty will not cover the damages caused by
unauthorized disassembling.
3. To prevent the device from malfunction, please make sure the device is connected with a
direct and dedicated power connection of a stable power input.
Chapter 6 Setting the Hard Drive Array Mode
Please select the RAID mode with the jumper located at the back panel. The original default
is RAID 1, still there are three pins at the back panel for RAID mode selection:
RAID 0 mode by setting the jumper on the bottom of the two pins.
RAID 1 mode by setting the jumper on the top of the two pins.
1. RAID 0 Mode
1). Place two new hard drives into iR2620 / SR2611 and strongly suggest you to use two
identical hard drives to get the equal capacity. If the capacity is different, iR2620 /
SR2611 is downward to the small hard drive capacity.
2). Under RAID 0 mode, capacity is add up to a one big volume, also with the feature of
faster read/write performance efficient.
2. RAID 1 Mode
1). Place two new hard drives into iR2620 / SR2611 and strongly suggest you to use two
identical hard drives to get the equal capacity. If the capacity is different, iR2620 /
SR2611 is downward to the small hard drive capacity.
2). Under RAID 1 mode, two hard drives has the identical information as one to mirror to
the other one, therefore each of the hard drive failed is still able to function normally.
When you replace the failed hard disk to the new one the system automatically
rebuilding the data to the newly place hard disk.
8
Setting the Hard Drive Array Mode
