Raider RDP-ETC26T, Руководство пользователя

Страница: 13 / 76

13
problem.
2.12. Allow the motor to come to full speed
before cutting.
2.13. Allow the motor to come to a full stop
before attempting to remove any jammed or
off cut material from around the blade area.
2.14. Never touch the moving parts or the
blade during use.
2.15. Never remove loose splinters, chips
pieces while the blade is moving.
2.16. Ensure that cut off tile pieces are not
caught by the blade and send flying.
2.17. Never walk away from the too until the
motor has come a complete stop. Never leave
the tool unattended when it is plugged into an
electrical outlet. Turn off the tool, and unplug
it from its electrical outlet before leaving.
2.18. Never allow the blade to run dry.
Cutting with a dry blade will cause excessive
wear and possible damage to the blade and
motor.
2.19. When transporting the machine, use
only transportation devices and do never use
guards for handling or transportation.
3. ASSEMBLY INSTRUCTIONS
WARNING! Never connect the plug to
power source outlet until all installations and
adjustments are completed and you have read
and understood the safety and operational
instructions.
Installing the stand
Fig.1
• Assemble the four legs to the table.
• Take care to tighten the bolts firmly, so
that the machine stands securely.
• Place the water reservoir in the table, and
secure it in place.
• Place the machine in the water reservoir.
Check that the power supply and electrical
outlet used are in accordance with your wet
saw. Have a look at the rating plate on the wet
saw. Any changes should always be carried
out by a qualified electrician.
WARNING! This machine must be earthed.
If not properly earthed this machine can cause
an electrical shock. Be sure that the power
supply outlet is earthed. If there is any doubt,
have it checked by a qualified electrician.
4. Operating Instructions
Read and understand the following items
about your tile cutter before attempting to use
the machine.
Fig.1
• Adjust the required tool position, then
tighten all the adjusting knobs, fence bolts
and mitre gauge bolts.
• Turn on the main switch and allow your
tool to reach the maximum speed before
commencing cutting.
• Hold the workpiece firmly against the
work table and fence, then feed machine
smoothly and evently to the workpiece.
• Cutting actions tends to slow the
blade down. Pressure should therefore be
occasionally released to allow the blade to
regain the full speed.
Warning! Do not attempt topick up an off-
cut or to remove the holding workpiece before
the cutting blade has completely stopped. If
holding the workpiece by hand take extreme
care and ensure hand is kept away from the
cutting blade.
● Connect the machine to mains by using
an approved RCD circuit breaker.
● Make sure you have marked your tile for
cutting.
WARNING! Do not allow your hands or
fingers to protrude over the notches at the
back edge of the sliding table. The blade will
enter this space during the cutting operation.
● Carefully follow your working line
adjusting tile cutting position if required.
● Never cut dry. Be sure the blade remains
wet during cutting operation. Frequently
check the water level in the water tray and
add water as often as necessary. Make sure
the pump is well below the water level.
● If the motor slows down, slow down your
feed rate or pull the tile smoothly back from
the blade.
● Wipe clean top with sponge during use
to reduce build up of debris. Always ensure
the machine is switched off when carrying out
this action.
● Stop the machine by using the on/off
switch. Allow the blade to come to a stop on
its own. Do not manually stop the blade by
grabbing it or holding an object against it.
WARNING! Do not attempt to pick up an
off-cut or to remove the holding tile before the