Raider RD-WP39, Оригинальное руководство пользователя

Страница: 13 / 78

13
Areas of use
This pump is used primarily as cellar pump.
When installed in a shaft, this pump pro
-
vides protection from flooding.
They are also used wherever
water has to be moved from one place
to another, e.g. in the home, agriculture,
horticulture, plumbing and many other ap
-
plications.
Setting to work
After having read these instructions care
-
fully, you can set your pump to work, recon -
sidering the following items:
• Check if the pump rests on the ground of
the shaft.
• Check of pressure cord has been at
-
tached properly.
• Check if electrical connection is 230
V~50 Hz
• Check if socket is in good condition.
• Make sure that water and humidity can
never come to the mains supply.
• Avoid pump running dry.
Important! Note!
• Remove the mains plug before all main -
tenance work.
• In the event that the pump is often trans
-
ported in the course of operation, it should
be cleaned out with clear water after every
use.
• In case of stationary installation, the
function of the loating switch should be
checked every 3 months.
All fibrous particles which may have built-up
inside the pump housing should be re
-
moved with
• Every 3 months the shaft ground and as
should be cleaned from mud.
• Remove deposits on the floater with
clear water.
Cleaning the impeller
If excessive deposits collect in the pump
case you must dismantle the bottom part of
the pump as follows:
1. Remove the intake cage from the pump
case.
2. Clean the impeller with clear water.
Important! Do not put down or rest the
pump on the impeller!
3. Assemble in reverse order
Setting the ON/OFF operating point
The ON and OFF operating point of the
float switch can be set by adjusting the float
switch in its latching holder.
Before you put the pump into operation,
please check the following:
The float switch must be installed so that
the level of the ON operating point and the
level of the OFF operating point can
• be reached easily and with little force. To
check this, place the pump in a vessel filled
with water, raise the float switch carefully by
hand and then lower it again. As you do so,
note whether the pump switches on and off.
• Make sure that the distance between the
float switch head and the latching holder is
not too small. Proper operation is not guar
-
anteed if the gap is too small.
When you set the float switch, make sure
that it does not touch the base before the
pump switches off. Caution! Risk of dry-run-
ning