8
www.raider.bg
Important Safety Rules
1. Always wear safety goggles or glasses.
2. Always ensure machine is switched off before connecting to air supply.
3. Disconnect any machine from the air supply before changing blades or discs, and before servicing any
type of machine.
4. Always keep your air tool clean and lubricated. Daily lubrication is essential to avoid internal corrosion
and possible failure.
5. Do not wear watches, rings bracelets or loose clothing when using air tools.
6. Using only light weight coil hoses from a tool to the wall or compressor coupling. Do not fit quick change
couplings onto the machine as vibration can cause the coupling to fail.
7. Do not overload the machine. Allow the tool to operate at its optimum speed for maximum efficiency.
8. Do not increase the air pressure above the manufacturers recommended level, as excessive overload
can cause the machine casing to split. Also this creates excessive wear on moving parts and possible failure.
9. In the interests of safety and possible damage to the machine/operator, always ensure that the machine
has stopped before putting it down after use.
10. Always ensure that the work piece is firmly secured leaving both hands free to control the machine.
11. Always ensure that the accessories such as blades, discs, sockets, etc. are rated/designed for use
with the machine. Also correctly and securely fastened before connecting the machine to the air supply.
12. When grinding, sanding or cutting always wear an appropriate face mask or respiratory equipment.
13. Compressor and pipe during operation reach high tmpraturi. Touch lead to burns. Suction supercharged
gases or vapors must keep impurities that can lead to fire or explosions in the compressor. At discharge hose
sadinitel, the coupling part to the hose should be kept firmly in hand to prevent injuries caused by rapidly
bounces back hose. When working with blow-gun prdpazni wear glasses. Foreign bodies and blown parts
can easily cause a uvrzhdaniya. Blow gun with not blowing people do not clean clothes on your body.
Fields of application
Suitable for sandblasting processing of parts of the body and other metal parts must be free of rust, paint,
paint and more.
Please note that our products according to their purpose not manufactured for craft or industrial use. We
do not accept any liability if the appliance is used in industrial, handicraft or industrial enterprises, as well as
in equivalent activities.
The machine must be used only for the purpose J. Any further outside this use is not intended. For caused
damages or injuries of any kind responsibility of the user / servicer, and not the manufacturer.
Air supply
1. Ensure Tool air valve (or trigger) is in the “off” position before connecting to the air supply.
2. You will require an air pressure of 90psi, and an air flow according to specification.
3. WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the wrench.
Too high an air pressure and unclean air will shorten the product life due to excessive wear, and may be
dangerous causing damage and/or personal injury.
4. Drain the air tank daily. Water in the air line will damage the wrench.
5. Clean air inlet filter weekly. Recommended hook-up procedure is shown in fig 1.
6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The
minimum hose diameter should be 1/4” I.D. and fittings must have the same inside dimensions.
7.
Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all
connections are secure.
Lubrication
An automatic in-line filter-regulator-lubricator is recommended (Fig4) as it increases tool life and keeps
the tool in sustained operation. The in-line lubricator should be regularly checked and filled with air tool oil.
Proper adjustment of the in-line lubricator is performed by placing a sheet of paper next to the exhaust
