Raider RD-MS06, Руководство пользователя

Страница: 19 / 86

19
• Unscrew the knob (9) a half turn
clockwise.
• Turn the machine to the desired angle
(the
angle can be read off on the front of the
machine).
• Screw up the knob (9) a half turn
anticlockwise.
• The turntable clicks into place at the
following angles: 0º, 15º, 22.5º, 30º and 45º
(both left and right).
Setting up the double sawing angle /
mitring Fig. 2
• Adjust the first angle as described for
adjusting the saw angle (above).
• Turn the knob (12) anticlockwise and then
set the angle desired (you can read this off
on the back of the machine. Then tighten the
knob (12) again by turning it clockwise.
Changing the carbon brushes Fig. 1
• Make sure that the plug is not in the
socket!
• Unscrew the covers (4) with a flat bladed
screwdriver. Remove the carbon brushes with
the same type of brushes. Screw the covers
(4) tight again.
Note: Always replace both carbon brushes
at the same time. Never use a mixture of old
and new brushes.
Mounting the dust bag Fig. 2
Press in the clamp of the dust bag (13) and
slide it onto the opening on the back of the
machine.
The dust bag stays in place when you
release the clamp.
8. OPERATION
Using the mitre saw Fig. 1
Before use, always check for faults or
defects!
• Set the desired sawing angle of the
machine.
• Put the plug into the socket.
• Fix the piece of work in place using the
clamps (7): make sure that the material is well
clamped in place!
• Hold the material tightly on the left side
while making sure that you keep a safe
distance from the blade of the saw.
• Turn on the machine using the switch (1).
• Make sure that the saw blade has reached
full speed before allowing it to touch the piece
of work to be sawn.
• Use knob (3) to raise the protective cover
lock.
• Now bring the saw slowly downwards so
that the saw blade saws through the piece of
work and passes through the slot in the table.
Do not put any pressure on the saw. Give the
machine time to saw through the piece of
work.
• Bring the machine gently up again and
switch it off by letting go of the switch (1).
Using the slide-function Fig. 1
The machine must be firmly bolted to a
workbench.
Use the slide-function for sawing wide
workpieces:
• Fix the piece of work in place using the
clamp
• Screw up the knob (10) a half turn
anticlockwise.
• Slide the machine completely towards
yourself
• Turn on the machine using the switch
• Bring the saw slowly downwards so the
saw blade saws through the piece of work
• Push the machine slowly backwards (in
direction of guide fence)
• Bring the machine gently up again and
switch it off by letting go of the switch
Using the laser Fig. 2
• To switch on the laser , press the on/off
switch 2.
• To switch off the laser , release the on/
off switch 2.
9. SERVICE AND MAINTENANCE
Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
Slide rails
Dirt can damage the slide rails and
thereupon the operating of the machine.
• Clean the slide rails regularly with a soft
cloth.
• Drip some lubricating oil on the slide rails
• Move the mitre saw forwards and
backwards so the oil spreads over the
complete rails
These machines are designed to function
for a long time without any problems with a
minimum of maintenance. By cleaning the
machine regularly and using it in the correct
way you can contribute to a long life of your
machine.