Raider RD-MS06, Руководство пользователя

Страница: 15 / 86

15
1.4.4. Store idle power tools out of the
reach of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool. Power
tools are dangerous in the hands of untrained
users.
1.4.5. Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool’s operation. If
damaged, have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
1.4.6. Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
1.4.7. Use the power tool, accessories
and tool bits etc. in accordance with these
instructions, taking into account the working
conditions and the work to be performed. Use
of the power tool for operations different from
those intended could result in a hazardous
situation.
2. Intended use
The electro tool is intended as a stationary
machine for making straight lengthways and
crossways cuts in wood. Horizontal mitre
angles of -45° to +45° as well as vertical bevel
angles of -45° are possible.
3. Check the machine, loose parts and
accessories
for transport damage.
Features
Figs. 1, 2 and 4
1. On/off switch
2. On/off switch for laser
3. Unlock button (Blade protective cover)
4. Cover carbon brush
5. Lock-pin
6. Blade protective cover
7. Workpiece clamp
8. Guide fence
9. Knob adjusting saw angle
10. Locking knob
11. Fixing knob clamp
12. Handle adjusting bevel angle
13. Connection dust bag
14. Slide rail
15. Bevel angle
16. Handle
17. Cover
18. Saw blade bolt
19. Flange
20. Screw
21. Extension pieces (left and right)
22. Lock-button saw blade
4. Additional safety instructions
4.1. When using the saw blades with hard
metal teeth (Carbon tipped) it is advisable to
use blades with a negative or slightly positive
cutting angle. Do not use any saw blades with
deeply cut teeth. They can grip the protective
cap.
4.2. Attention: First carefully assemble
all the parts before starting work. Follow the
procedure as indicated.
4.3. If you are not familiar with using such a
machine, you would be better to be informed
first by a professional, an instructor or by a
technician.
4.4. Always clamp or press the workpiece
firmly against the saw guide, before you
carry out the process. The use of all possible
clamping set-ups is preferable to using your
hands.
4.5. Important: If you are holding the
workpiece by hand for the process to be
carried out, keep a minimum distance of 100
mm from the saw blade.
4.6. Always press the workpiece against
the bench.
4.7. Keep the saw blade sharp and check
regularly whether it rotates freely without
abnormal vibrations. Replace the saw blade
if necessary.
4.8. Allow the machine to rotate freely
until it reaches the maximum number of
revolutions, before you start the process.
4.9. Maintain the air inlets at the back and
the bottom of the bench saw machine and
electric engine for a longer machine life. Dust
piles must be removed.
4.10. Always lock the different degree set-
ups before you start processing.
4.11. Only buy suitable saw blades with
a number of revolutions of at least 4500
revolutions per minute.
4.12. Only use the correct saw blade. Too
small or too big saw blades are extremely
dangerous.
4.13. Regularly inspect the saw blade for
any faults. Replace the saw blade if necessary.
4.14. Grease the new saw blade and clean
the flanges before you assemble the new