7
General guidelines for safe operation.
Read all instructions carefully. Failure of the considered below instructions may
result in serious injuries. Keep these instructions in a safe place.
1. Safety.
1.1. It is forbidden to use the hydraulic jack by persons who are not familiar with this
instruction manual.
1.2. Portable hydraulic jack is designed exclusively for lifting vehicles, as a couple
optional wheels are constantly in contact with the ground.
1.3. Prohibited to the lifting of the vehicle when it is man.
1.4. Jack should be placed only in designated by the manufacturer of the vehicle
lifting points for him.
1.5. After lifting and before any work on the vehicle, it must be a fixed brace
supports.
1.6. Not permitted congestion jack. It will lead to injury or danger to the user.
1.7. Jack is intended for use only on hard surfaces with a high load. Use on soft
surfaces or those with insufficient load will cause a drop in vehicle and / or serious
accidents and injuries.
1.8. Use the jack only if the supporting surface below the horizontal.
1.9. Do not put hands or feet under the vehicle with jack raised.
1.10. Observe the requirements described in this instruction. Failure to comply with
specified rules may lead to a fall in vehicle damage to the jack and / or severe injuries.
2. Functional description and purpose. Purchased by you rolling hydraulic jack is
designed for lifting vehicles. He works on a hydraulic principle. In the closed valve
(2) and upward movement of the lever (1) control jack, hydraulic oil reservoir within
the cylinder of the hydraulic pump (3). When moving the lever (1) below, the hydraulic
pump oil transfer and increases the pressure in the cylinder of the power jack. Saddle
of the jack starts to move upwards. If the load exceeds the maximum capacity of the
jack, it automatically lift and suspend oil from the power cylinder through a safety
valve passes into the oil reservoir. When the jack to raise the maximum height, then
the hydraulic oil passes through a special channel and back into the oil reservoir. This
prevents any damage to the jack.
Unscrew the valve (2) allows the oil from the power cylinder to move in the oil tank.
So the pressure in the cylinder and reduces the jack is lowered slowly down.
3. Preparing to work with jack.
The transport of jack as possible in the hydraulic system to penetrate air.
3.1. Venting.
With the help of leverage (1) turn the valve (2) in the direction counterclockwise no
more than two complete revolutions. You’ll see at the back side of the power cylinder,
rubber stopper for filling the hydraulic oil. Remove the stopper and vigorously inflate
lever (1), while pressing the saddle jack in bottom end position. If necessary, repeat.
After venting necessarily put the stopper back in the hole.
4. Using jack.
4.1. Lifting.
Vehicle must be on a hard and flat surface with the handbrake pulled. Put the wedge-
shaped supports at least one wheel. Turn the valve (2) with the help of leverage (1) in a
clockwise direction, close to point blank range. Find the core points of the vehicle on
jack, which are specified by the manufacturer. Place the jack so that the center of his
saddle (6) to just below the point of support for lifting the vehicle. Inflate with a lever
to lift the jack to the bottom of the vehicle. Check again if the saddle (6) is located just
below the point of support. Jack Continue until you reach the desired height. Then
place the stationary support. Slowly lower the vehicle on the supports, as carefully and
slowly uncovered the valve (2) in the direction of counterclockwise. Finally, remove the
jack.
Содержание RD-HB02
Страница 22: ...22 ...