Raider RD-GSC03, Руководство пользователя

Страница: 28 / 126

28 www.raider.bg
9.3.1 Use a four-stroke engine oil that meets or exceeds the SF, SG, SH API, or equivalent class
performance requirements.
9.3.2. Select the optimum viscosity of the oil that corresponds to the ambient temperature at which
you will operate the machine. DO NOT mix oils!
9.4. OIL LEVEL CHECK AND ADD
Note: Check the oil level only when the engine is off and cooled down. The machine must be level.
9.4.1. Remove the oil filter cap / oil dipstick and dry it thoroughly.
9.4.2. Fully insert the oil filter / oil gauge cap into the oil filler neck, do not screw in. Then remove it.
After pulling out, look at the oil level.
9.4.3. If the oil level is near or below the lower boundary marker, remove the oil filter cap / dipstick
and add oil to the engine between the upper and lower markings. Do not overfill.
9.4.4. Replace the oil filter cap / dipstick.
9.4.5. ATTENTION! Make sure the oil switch open and choke switch closed, check the right
photos
Change oil according to MAINTENANCE / OIL CHANGE.
ATTENTION! Improper filling or insufficient oil may cause irreparable damage to the engine.
9.5. CHECKING THE ENGINE BEFORE OPERATION
9.5.1. For your safety and for the maximum service life of your equipment, it is very important to take
a few minutes to check the condition of the engine before operating.
ALWAYS CHECK THE FOLLOWING ELEMENTS BEFORE STARTING THE ENGINE:
- Fuel level
- Oil level
- Air filter (if any)
General management: Make sure there are no leaks, inspect for loose or damaged parts.
- Check engine power.
ATTENTION! Make sure that you have taken care of the problem you find, or if you are not sure,
have the machine serviced by an authorized workshop to correct the malfunction before operating the
machine. Improper maintenance of this engine or inability to correct a problem before you start working
can cause a malfunction that can be seriously affected or even death.
9.6. HIGH HEIGHTS
9.6.1. Engines operating at high altitudes (over 1600 meters above sea level) require special attention
as the saturation of the fuel mixture is reduced and saturation is achieved. This results in loss of power
and higher fuel consumption. Contact an authorized service center for more information.
10. WORK
ATTENTION: THE MACHINE IS INTENDED FOR OPERATION ONLY DRIVING FORWARD. As you