Raider RD-EW05, Руководство пользователя

Страница: 9 / 30

9
- Move Freewheeling clutch to the “Out” position.
- Extend cable assembly to its full length. Note how the existing cable is connected to the inside
of the drum.
- Remove old cable assembly and attach new one.
- Retract cable assembly onto cable drum being careful not to allow kinking.
5. Troubleshooting.
SYMPTOM POSSIBLE CAUSE SUGGESTED ACTION
Motor does not turn On 1.Switch not connected properly
2.Loose battery cable
connections
3.Solenoid malfunctioning
4.Defective switch 5.Defective
motor 6.Water has entered motor
. Insert Switch all the way into
connector2. Tighten nuts on all
cable connections 3.Tap solenoid
to loosen contacts. Apply 12 volts
to coil terminals directly. A clicking
indicates proper activation 4.
Replace switch 5.Check for
voltage at armature port with
Switch pressed. If voltage is
present, replace motor. 6. Allow to
drain and dry. Run in short bursts
without load until completely dry
Motor runs but cable
drum does not turn
Freewheeling clutch not engaged Move the Freewheeling clutch to
the “In” position. If problem still
persists, a qualified technician
needs to check and repair
Motor runs slowly or
without normal power
Insufficient current or voltage Battery weak, recharge. Run
winch with vehicle motor running-
Loose or corroded battery cable
connections. Clean, tighten or
replace.
Motor overheating Winch running time too long Allow winch to cool down
periodically
Motor runs in one
direction only.
1. Defective or stuck solenoid
2. Defective switch.
1. Tap solenoid to loosen
contacts. Repair or replace
solenoid
2. Replace switch.