Raider RD-CIW01, Руководство пользователя

Страница: 11 / 92

11
The cordless screwdriver is designed for screwing and unscrewing screws and bolts in wood, metal and plastics as well as
drilling holes in the listed materials. Power tools with cordless, cordless power supply are especially suitable for work related
to interior decoration, room adaptation, and more.
It is not allowed to use the power tool for activities other than its intended purpose!
3. Noise and vibration data.
Sound pressure level: LpA =92,67 dB (A);
Sound power level: LwA = 103,67dB (A);
Vibration acceleration value: ah = 24,905 m / s2.
4. Preparing for work.
4.1. Inserting and removing the battery.
Set the direction change switch to the center position to protect the power tool from accidental starting. Place the charged
battery in the handle so that it snaps into place and faces the handle.
4.1.1. Remove the battery from the handle by pressing the battery lock button down and pull the battery forward and down
from the base of the tool.
4.1.2. Check that the power supply voltage of the data plate corresponds to the available voltage.
4.1.3. Slide the battery on the charger. It takes about 3 hours to fully charge the empty battery.
4.1.4. During charging, it is normal for the battery to warm up slightly. If you can not reload, check:
- there is voltage in the electrical socket.
- Make sure the charger contacts are not damaged and are in contact with the battery.
- If the battery still does not charge, please contact an authorized service center.
4.2. Charge the battery.
The battery wiper is supplied with a partially charged rechargeable battery. The battery must be fully charged before use.
Charging should be carried out at an ambient temperature in the range of 4 ° C to 40 ° C. A new battery or one that has not
been used for a long time acquires its full capacity after about 5 charging and discharging cycles.
The grid voltage must correspond to that indicated on the charger plate.
Before starting charging, always check the charger status and the power cord first.
To charge the battery, only the charger supplied with the battery wrench must be used.
The charger must not be subjected to rain, moisture or liquid pouring.
Battery Capacity Indicator:
You can check the battery power status by pressing the power button on the back of the battery.
- All LEDs glow: The battery is fully charged.
- The yellow and red LEDs light up: The battery has sufficient remaining charge.
- Red LED: The battery is empty, charge the battery.
LED lamp
The LED lamp can be used in poor lighting conditions to illuminate the work area. The LED will light up immediately after
you press the trigger
BEFORE USE
Important! Always lock the switch and remove the battery from the machine before operating the machine!
5. Operating the machine
To start up, press the starter switch and hold it down. To turn off the machine, release it. The revolutions depend on the
pressure you apply to the trigger switch. The slight pushing of the trigger switch results in low speed. Further pressure leads
to an increase in speed.
Attention! Do not use the direction switch until the machine has stopped working completely!
5.1. Working clockwise / right rotation:
• Press the switch clockwise / F /