31
bagging adaptor on the mower. While holding the lower handle lift up the rear section of the
grass catcher as shown in Figure 9. the box will open and the grass clippings will fall out.
See Figure 8. When replacing your grass catcher, be sure the top of the box rests on the wire
support between the handles.
SECTION 7: MAINTENANCE
WARNING: be sure to disconnect and ground the spark plug wire before performing
any repairs or maintenance. Replace worn or damaged parts for safety. NOTE: when tipping
the unit, empty the fuel tank and keep the engine spark plug side up. Never tip the mower
more than 90 degrees and do not leave the mower tipped for any long time. Oil can drain into
the upper part of the engine causing a starting problem.
■
ENGINE
Refer to the separate engine manual for all engine maintenance instructions. Maintain
engine oil as instructed in the separate engine manual packed with your unit. Read and
follow instructions carefully.
Service air cleaner every 25 hours under normal conditions. Clean every few hours under
extremely dusty conditions. Poor engine performance and flooding usually indicate that the
air cleaner should be serviced. To service the air cleaner, refer to the separate engine manual
packed with your unit. The spark plug should be cleaned and the gap reset once a season.
Spark plug replacement is recommended at the start of each mowing season.Check engine
manual for correct plug type and gap specifications.
Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing
area) clean to permit proper air circulation which is essential to engine performance and
life. Be certain to remove all grass. Dirt and combustible debris from muffler area.
■
DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup
of grass clippings. Leaves, dirt of other matter. If this debris is allowed to accumulate, it will
invite rust and corrosion.and may prevent proper mulching, discharge or bagging.
The deck may be cleaned by tilting the mower and scraping clean with a suitable tool
(make certain the spark plug wire is disconnected).
CUTTING BLADE REMOVAL, REPLACEMENT AND SHARPENING STRAIGHT BLADE.
Following steps shall be performed by professional maintenance staff of our company or
dealers.
Содержание Power Tools RD-GLM01S
Страница 35: ...35 SPARE PART ...
Страница 49: ...49 SPARE PART RD GLM01S ...
Страница 50: ...50 www raider bg PART LIST RD GLM01S ...