Raider Power Tools RD-GCS15, Руководство пользователя

Страница: 21 / 72

21
1.6.25. Always stand to the side of predicted fall line of the tree that is to be cut.
1.6.26. During a tree fell there is a risk that branches of the tree, or trees in proximity,
will break and fall. Be very careful, otherwise a body injury may occur.
1.6.27. On a sloped terrain the operator should stay on upper part of the slope with
respect to the tree being cut, never lower.
1.6.28. Watch out for logs that may roll down towards you. Jump away!
1.6.29. Operating saw tends to rotate when tip of the chain guide bar touches processed
material. In such case the saw may get out of control and move towards the operator
(risk of body injury!).
1.6.30. Do not use the saw above your shoulder level, or when standing on a tree,
ladder, scaffold, trunk etc.
1.6.31. Avoid touching the muffler. Hot muffler may cause severe burns.
1.7. To prevent saw recoil follow below instructions.
1.7.1. Never start or guide a cut with the tip of the guide bar!
1.7.2. Always start cutting with saw previously switched on!
1.7.3. Ensure the cutting chain is sharp.
1.7.4. Never cut more than one branch at a time. When cutting off, watch out for
surrounding branches. When cutting a tree through, watch out for nearby tree trunks.
2. Construction and use.
Petrol chain saw is a hand-held tool. It is driven by an air cooled, two-stroke
combustion engine. Tool of this type is designed for tasks in home garden. The saw
can be used for cutting down trees, cutting branches, firewood, wood for fireplace and
other tasks where cutting wood is necessary. Petrol chain saw is a tool for amateur use
only.
Use the device according to the manufacturer’s instructions only.
3. Preparation for operation.
3.1. Carrying the chain saw.
Prior to carrying the chain saw slide chain cover onto guide bar and chain. When
carrying the chain saw, hold it by front handle. Do not carry the saw when holding main
handle. If several cuttings are to be made, switch off the chain saw with the ignition
switch between consecutive tasks.
3.2. Installation of guide bars and saw chain.
Prior to guide bar installation remove plastic transport spacer, placed on guide
fixing screws under the guard. Use pin and adjustment screw for adjustment of chain
tension. It is very important that the bolt located on adjustment screw falls into hole in
the guide bar during installation of the guide bar.
You can move the bolt to the front and back by turning the adjustment screw. Those
parts must be set appropriately prior to starting guide bar installation in the saw.
Guide bar and chain are supplied separately.
Brake lever (6) must be in the upper (vertical) position.
Unscrew the guide bar fixing nuts (7) and remove the casing (10).
Put the chain (21) onto driving chain wheel located behind the clutch.
Install the guide bar (20) (slide it behind the clutch) onto guiding screws and push
towards driving chain wheel.
Put the chain (21) onto guide bar chain wheel (22) from below.