20
c. Tool Kit and spare parts
d. Corrosion Protection
Whenever possible after use in sea water or submersion in sea water, wash entire engine
with fresh water to remove salt deposits and wipe down with a dry cloth. Spray entire
powerhead with a liberal coat of Anti-Corrosion Spray penetrant/lubricant or equivalent.
Though not specifically mentioned as a service procedure, Anti-Corrosion Spray or equiva-
lent should be applied after any service repairs under the engine cover and repeated at reg-
ular intervals to protect powerhead components. Anti-Corrosion Spray leaves a thin, non-
messy, transparent film that actually lifts water and moisture from metal surfaces. It protects
equipment and tools that are left outdoors, even in humid coastal areas. Anti-Corrosion
Spray dries out ignition systems to start wet engines and stops moisture-induced short cir-
cuits in electrical systems.
e. Optional Accessories
1) Both the 50 and 40 Horsepower can be purchased with a battery system that is enclosed
under the cowling. This battery is safe underwater; can be recharged by the Raider motor
once the motor is started.
2) Both the 50 and 40 Horsepower can be fitted with a dual motor single operator assembly
that can quickly be attached to twin motors for a single operation. The motors come with a
preset in each tiller arm and an assembly to control the throttle with a remote cable that at-
taches to the second motor. This controls throttle for both engines.
a
a
a
Emergency strap
