12
i. Stopping Raider
1. Slow engine to idle speed.
2. Move shift lever to NEUTRAL position.
3. Press and hold stop button until the engine stops running.
j. Trim Angle
Engine should be perpendicular to water when boat is underway. This ad-
justment can only be determined by water testing the boat. Set angle ad-
justment for NORMAL boat load.
Move angle adjusting stop rod as shown in picture.
k. Trailering
Place the engine in the normal vertical position. For additional road clearance, move angle adjusting
rod to an outer stern bracket position. Refer to
Raider Trim Angle
.
DO NOT
use the tilt support as a Trailering bracket. The engine should always be resting
on the angle adjusting stop rod when under full power or when trailering.
l. Tilting
DO NOT push down on tiller handle to tilt engine.
Raise Raider
1. Move tilt/run lever to the TILT position.
2. Use tilt grip on engine cover to raise engine. When desired
angle
is reached, move lever to lock position.
Lower Raider
1. Move tilt/run lever to RUN position. Engine will lower to set run position.
Tilt the engine
up entirely
