Rage Super Cub 750, Инструкция по эксплуатации

Страница: 5 / 12

5
Super Cub 750 Assembly
The Super Cub 750 comes nearly ready to fly, all that
is required to complete is the installation of the
landing gear.
Insert the landing gear wire into the slot at the front
of the battery box. Fasten the two supplied screws to
secure the gear as shown using the included Philips-
head screwdriver.
Center of Gravity
The center of gravity (CG) for the Super Cub 750 is a point that is 30mm + or - 5mm back from
the leading edge of the wing where it meets the fuselage. Maintaining the correct CG is critical
to optimum flight performace. A plane with too aft a CG (tail heavy) will be very pitch sensitive
and difficult to control. If the CG is too far forward (nose heavy) the plane will be too pitch
stable and not responsive enough.
With the supplied battery installed in the battery box the Super Cub’s CG will automatically be
in the correct location. If a different battery is used or repairs have been made to the airframe
the CG should be rechecked and weight adjusted to acheive the proper CG.
Super Cub 750 RTF Contents
Battery Install
Insert the battery into the battery box located on the
bottom of the fuselage. Turn the transmitter on first with
the throttle off (left transmitter stick all the way down)and
then plug the JST (red) connector in, this powers up the
aircraft.
The Super Cub 750 includes a bright LED light in the nose of
the aircraft. Plug the balance connector (white) in to
activate the LED. Unplug both at the end of each flight.