Rage Micro VINTAGE STICK, Инструкция по эксплуатации

Страница: 6 / 12

6
Right trim button under left stick.
This button is pressed and held
during all servo reversing steps.
Please Note: This is a step that should not be required. It is included in the event that
a servo has become reversed and needs to be changed. Always check the direction of
travel of the control surfaces as part of your preflight safety check before every flight.
Servo Reversing
PLEASE NOTE: Install 4 AA batteries ( not supplied ) into the battery compartment
located on the back of the transmitter, under the battery hatch cover. Make sure
that the batteries are installed with correct polarity per the diagram inside the
battery compartment.
Elevator Trim
Rudder Trim
Charge Indicator Light
Antenna
Flight Battery
Charger Inside
Throttle Stick
Not Used for
This Model
Throttle Trim
Power Switch
Power Light
Rudder/Elevator
Stick
Handle
Transmitter Details
The Micro Vintage Stick transmitter features servo reversing on the rudder and elevator
channels. The servo direction was set correctly at the factory for the model. However, in case
any of the controls are operating in the wrong direction or you use the electronics in other
models later on, please follow these steps to change the servo directions as needed. Complete
all steps with the transmitter and aircraft powered on.
Rudder Channel Servo Reversing
Press and hold the right trim button under the left stick, then
press the right trim button under the right stick. Release both
buttons and the servo direction will be reversed. Repeat to
change back.
Elevator Channel Servo Reversing
Press and hold the right trim button under the left stick, then
press the down elevator (top) trim button. Release both
buttons and the servo direction will be reversed. Repeat to
change back.