7
out. If the calibration failed, the red “Fail” LED on the cradle will be
lit. After all functions have been performed, the battery will resume
charging.
Calibrating and Bump Testing Multiple Monitors
Calibrating and Bump Testing Multiple Monitors
The AutoRAE system will only bump test/calibrate one monitor at a
The AutoRAE system will only bump test/calibrate one monitor at a
time. When multiple monitors are in AutoRAE cradles connected to
time. When multiple monitors are in AutoRAE cradles connected to
the AutoRAE controller, the AutoRAE will bump test/calibrate the
the AutoRAE controller, the AutoRAE will bump test/calibrate the
monitors in the order that they were selected. While the second through
monitors in the order that they were selected. While the second through
last monitors are waiting to be tested/calibrated, the LED of the selected
last monitors are waiting to be tested/calibrated, the LED of the selected
function will flash and continue to flash until the bump test/calibration is
function will flash and continue to flash until the bump test/calibration is
completed.
completed.
Disconnecting the AutoRAE System
Disconnecting the AutoRAE System
You may disconnect cradles from the AutoRAE controller and from
You may disconnect cradles from the AutoRAE controller and from
each other by pressing the small rectangular button with a circle on top,
each other by pressing the small rectangular button with a circle on top,
located on the top right of the cradle, and pulling the cradle away. It is
located on the top right of the cradle, and pulling the cradle away. It is
recommended that you connect and disconnect cradles only when the
recommended that you connect and disconnect cradles only when the
AutoRAE controller is powered off.
AutoRAE controller is powered off.
Communication
connection
connection
Side of AutoRAE cradle/controller.
Alignment
Alignment
guide
guide
Press button to
disconnect
Gas
connection
connection
