6
button and green “Bump” LED will both begin to flash. You can
toggle between the “Bump” and “Cal” LEDs and no selection/cancel
while the “Start” button is flashing. The selected function’s LED (no
LED in the case of no selection/cancel) will flash at this time.
4. Select the bump test function (“Bump”). The “Start” button will stop
flashing after 10 seconds, and the current selection will be locked in.
The AutoRAE will then proceed to bump test the monitor. During
this time, the green “Cal/Bump” LED on the AutoRAE controller will
be lit, and the green “Bump” LED on the cradle will continue to flash
until the bump test is done (about 3 minutes). Upon completion of
the bump test, the “Bump” LED on the cradle will stop flashing and
remain lit is the monitor passed the test. The “Cal/Bump” LED on
the controller will also go out. If the monitor failed the bump test,
the AutoRAE will automatically start to calibrate the monitor (see
Calibrating a Monitor). After all functions have been performed, the
battery will resume charging.
Calibrating a Monitor
1. Turn on the AutoRAE system.
2. Place the monitor to be calibrated into an AutoRAE cradle. The green
“Charge” LED will begin flashing, and the battery will begin to charge.
3. Press the white “Start” button on the front of the cradle. The “Start”
button and green “Bump” LED will both begin to flash. You can
toggle between the “Bump” and “Cal” LEDs and no selection/cancel
while the “Start” button is flashing. The selected function’s LED will
flash at this time. Note: The LED does not flash in the case of no
selection/cancel).
4. Select the calibration function (“Cal”). The “Start” button will stop
flashing after 10 seconds, and the current selection will be locked
in. The AutoRAE will then proceed to calibrate the monitor. During
this time, the green “Cal/Bump” LED on the AutoRAE controller will
be lit, and the green “Cal” LED on the cradle will continue to flash
until the calibration is done (about 5 minutes). Upon completion of a
successful calibration, the “Cal” LED on the cradle will stop flashing
and remain lit. The “Cal/Bump” LED on the controller will also go
