by Honeywell
Bump And Cal Errors And Status Messages
Status
Bump LED
Cal LED
User Action
Warm-up in
progress
Orange (blinking in alternation) Do not remove the instrument from the cradle, or the warm-up
process will be interrupted. Pressing keys has no effect.
Warm-up error
Red (blinking in alternation)
Remove the instrument from the cradle and take the action
indicated on the instrument’s display.
Warm-up
completed
successfully
Green
Green
Press Bump or Cal key to perform a bump test or calibration.
Bump test in
progress
Green
(blinking)
Off
Do not remove the instrument, or the process will be
interrupted. Pressing keys has no effect.
Bump test
completed
successfully
Green
Off
The bump test result (pass) has been logged. You may remove the
instrument from the Cradle for use or leave it on the Cradle for the
next AutoRAE 2 operation or to charge its battery.
Bump test failed Red (blinking
slowly)
Off
The bump test result (fail) has been logged. The AutoRAE 2
will perform calibration on failed sensor(s) automatically.
Calibration in
progress
Off
Green
(blinking)
Do not remove the instrument, or the process will be
interrupted. Pressing keys has no effect.
Calibration
completed
successfully
Off
Green
The result has been logged in the instrument. You may
remove the instrument from the Cradle.
Calibration
failed
Off
Red (blinking
slowly)
The result has been logged in the instrument; you may remove
it from the Cradle and read its display for an error code.
Sleep mode
Orange
Orange
Charging continues when in sleep mode. Press either key to
wake up the instrument.
Monitor not
connected /
system idle
Off
Off
Check to make sure the monitor is properly installed in the
cradle and the capture mechanism is fully engaged.
Check to make sure the monitor is in AutoRAE 2
Communications Mode or turned off.
Cradle error
Red (blinking slowly)
Take the action indicated in the Controller’s display.
Otherwise, contact RAE Systems service.
