Radyne ComStream SFC1450A, Инструкция по установке и эксплуатации

Страница: 107 / 156

SFC6400A/SFC1450A Synthesized Frequency Upconverter Appendix A
TM106 – Rev. 1.1 A-17
If successful, the converter will return the following string:
<cr><lf>
Channel: cc
{cc = current channel number, 00 to 30}
Frequency: ffff.fff {ffff.fff = frequency in MHz}
Gain: sgg.g {s = ± and gg.g = gain in dB}
Input Atten: aa dB {aa = input attenuation}
RF: {Off/On}
Stored Faults: {None/Signal Fault/LO Fault/LO Fault, Signal Fault}
Reference: {Internal/External}
<cr><lf>
<cr><lf>
{End of transmission}
A.13 Clear Faults Command (All)
This command clears any stored faults. The command is as follows:
@01/CLRFAULT<cr>
The converter will not return a string.
A.14 Auto Mode Command (P1: 1, B1: 1, B1: 8)
This command allows the operator to put the switch back into Auto Mode. The command is as
follows:
@01/AUTO<cr>
Note: For a 1:1 Switch configuration, if the front panel switch is accidentally left in the
Manual Mode, from the Remote Port send a manual command to the converter that is
‘Manually Deselected,’ i.e.; the one that is NOT selected. Then send an Auto Command to the
same converter and the switch will now be back in Auto Mode. For a 1:8 Switch
configuration, send the Auto Mode command to the backup converter.
If successful, the converter will not return a string.
A.15 Manual Mode Command (P1: 1, B1: 1)
This command allows the operator to force the switch to put the converter online and keep it there.
This command simulates the manual selection switch on the front panel. The command is as
follows:
@01/MANUAL<cr>
Note: For a 1:1 Switch configuration, if the front panel switch is accidentally left in the
Manual Mode, from the Remote Port send a manual command to the converter that is
‘Manually Deselected,’ i.e.; the one that is NOT selected. Then send an Auto Command to the
same converter and the switch will now be back in Auto Mode.
If successful, the converter will not return a string.