Radwin 2000+ SERIES, Руководство пользователя

Страница: 111 / 276

RADWIN 2000+ Series User Manual Release 4.2.40 6 ‐ 28
Configuration with Telnet
6.4 Configuration with Telnet
6.4.1 Telnet Access to Either ODU
A Telnet terminal can be used to configure and monitor the RADWIN 2000+ Series radio units.
To start a Telnet session on the RT ‐ A(HBS), use telnet <ODU_IP>.
For example, if you run Telnet as follows,
telnet 10.104.3.2
you will be asked for a user name and password.
The Telnet log on user name is the password that you used to enter the RADWIN Manager
(for example, the default: admin ). The Telnet password is the corresponding Community
string (default: netman ).
Figure 6 ‐ 14: Telnet session log on to the RT ‐ A(HBS)
A Read ‐ Only Community string allows you to use display commands only whereas a Read ‐
Write Community string allows you to use display commands and execute set commands.
Supported radio unit (ODU) Telnet commands are shown in Table 6 ‐ 2 to Table 6 ‐ 4 . They apply
to both RT ‐ A(HBS) and RT ‐ B(HSU)
Table 6 ‐ 2: ODU Telnet ‐ Display Commands
Command Explanation
display inventory
Displays radio unit product name, Name, Location,
hardware and software revisions, uptime, MAC
address.
display management Displays IP, subnet, Gateway, Traps table
display link Displays all static details about the link
display ethernet Displays Port table (State, Status and action)
display ethernet_errors Displays Cable statistics
display ntp Displays Time, Server and Offset