Retrieving Network Traffic Logs
This procedure describes how to retrieve log files that provide information about network
status. For more information about network traffic logs, see
“How to Retrieve SCOPIA XT
Series Logs” on page 34
.
Before you begin
•
Ensure you a computer you intend to use for retrieving logs is connected to the same
network as the SCOPIA XT Series.
•
It is recommended that you should clean the old logs from the RAM. In case there is not
enough room on the RAM, retrieving logs is automatically stopped.
Procedure
Step 1
Open a telnet session to the SCOPIA XT Series by connecting to its IP address on port 60123.
The command line window opens.
Step 2
At a prompt, enter this command:
cd NETLOG
Step 3
At the next prompt, enter
OK
.
Step 4
If there are logs you retrieved earlier on the RAM, remove them by using this command:
CAP-
CLEAR
.
Note
This command clears logs from both the unit’s RAM and flash memory.
Step 5
Define the interface card using this command:
CAP-SET-INTERFACE<type of interface>
Where the type of interface is one of these values:
•
eth0—for GLAN1
RADVISION | Administrator Guide for SCOPIA XT4000 Series Version 3.0
Troubleshooting | 35
