RADVision SCOPIA 400, Руководство пользователя

Страница: 137 / 208

Configuring the SCOPIA Gateway 127
Configuring Port Settings
C
ONFIGURING
P
ORT
S
ETTINGS
On the PRI Port or Serial Port tabs, you can configure physical line settings for
Gateway ports. The following topics discuss the settings you can configure.
Configuring Basic Port Settings on page 127
Configuring Port Physical Interface Settings on page 128
About Advanced ISDN Settings for PRI Gateways on page 135
Configuring Port Call Policies on page 146
Configuring Port Supported Services on page 148
Note
Some configuration options are unavailable in Gateways that support only
one PRI port.
C
ONFIGURING
B
ASIC
P
ORT
S
ETTINGS
In the Basics section of the PRI Port or Serial Port tabs, you can configure basic
settings for the specified port.
Note
(PRI Gateways only) A frame alignment failure message will appear when
you enable a port that is not in use (no cable is attached to the PRI line connector).
Procedure
1
In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2
Click the applicable PRI Port or Serial Port tab.
3
Select the Port enabled check box to enable this port. For PRI
Gateways and Serial Gateways, if this setting is deselected, the CD LED
light on the rear panel of the Gateway is disabled.
4
(PRI Gateways only) In the Port phone numbers section, choose one of
the following option buttons:
Single Number —Defines a single number for this PRI port. Enter a
phone number in the field.
Range —In the two fields, enter a range of numbers for this PRI line.
If the line has a range of numbers, you only need to enter the digits
necessary to indicate the range. For example, if the phone numbers
assigned to this line are 6775380 to 6775411, enter 380-411. You can
type a maximum of 31 digits in each text field.
5
(PRI Gateways only—optional) In the Local Area Code field, enter the
local area code for the phone numbers. You can enter up to 16 digits.